Complete the crossword, then click on "Check" to check your answer. If you are stuck, you can click on "Hint" to get a free letter. Click on a number in the grid to see the clue or clues for that number.

											1
									2
				3		4
5		6
		7
			8
		9							10
			11
														12
				13		14
									15

 Check 

Across: 2. This part of the machine holds turning tools 5. Used to set the lathe up to produce short tapers 7. What does the abreviation "CL" on a technical drawing stand for? 8. Type of 2D drawing style 9. It moves the lathe tool in the "X Axis" 11. What a three jaw chuck is attached to 12. What does the abreviation "SQ" stand for on a technical drawing 13. Where a revolving centre or dead centre may be located on a lathe 15. What does the letters "CU" stand for in the periodic table

Down: 1. What does the letters "AU" stand for on the periodic table 3. What does the term "C-bore" on a technical drawing stand for 4. A diamond pattern produced on metal to give extra grip is called what 5. What does the abreviation "C'sk" stand for when seen on a technical drawing 6. State the thre letter acronyme for maximum material condition 10. What type of techical drawing is drawn at 30 degrees from the horizontal 12. What does the abreviation "SQ" stand for in a techincal drawing 14. What does the letters "Fe" stand for in the periodic table